Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in work equipment, swing, and travel circuits

UEN00228-00 30 Testing and adjusting Approx. 20.5 MPa {Approx. 209 kg/cm 2 } 4) While fixing holder (6), tighten locknut (7). 3) While fixing adjustment screw (9), tighten locknut (10). 3 Locknut: 49 – 58.8 Nm {5 – 6 kgm} 3 Locknut: 78 – 103 Nm {8 – 10.5 kgm} 5) Connect pilot hose (5). 6) After finishing adjustment, check again that the oil pressure is normal according to the above described measurement proce- dure. 4) After finishing adjustment, check again that the oil pressure is normal according to the above described measurement proce- dure. 2.

Adjusting swing relief pressure a If the swing relief pressure is abnormal, adjust safety valve (8) of the swing motor according to the following procedure. 1) While fixing adjustment screw (9), loosen locknut (10). 2) Turn adjustment screw (9) to adjust the pressure. a If the adjustment screw is q Turned to the right, the set pres- sure is increased. q Turned to the left, the set pres- sure is decreased. a Quantity of adjustment per turn of adjustment screw: Approx. 6.7 MPa {Approx. 68.4 kg/cm 2 } 30 PC210, 230, 240-8