Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in pump PC control circuit

30 Testing and adjusting UEN00228-00 6) After finishing measurement, remove the measuring tools and return the removed parts. PC240-8 2. Measuring PC-EPC valve output pressure 1) Open the side cover of the pump room and remove oil pressure pickup plugs (5) and (6). (5): Front PC-EPC valve output pressure pickup plug (6): Rear PC-EPC valve output pressure pickup plug 3) Start the engine and move the arm cylin- der to the IN stroke end. 4) Set the working mode in the power mode (P) and turn the swing lock switch ON. a If the swing lock switch is turned ON, the main relief valve is set for high- pressure relief.

5) Run the engine at high idle, operate the left work equipment control lever to relieve the arm circuit at the IN stroke end, and measure the oil pressure. PC240-8 2) Install nipples L2 and connect them to oil pressure gauges [2]. a Use the oil pressure gauges of 5.9 MPa {60 kg/cm 2 }. a Measuring condition and method of judgment: If the pressures are in the following ratio, the PC valve is nor- mal. a If the PC valve or the servo piston is abnormal, the PC valve output pres- sure (servo piston inlet pressure) is "the same as the pump discharge pressure" or "almost 0".

PC210, 230, 240-8 33 PC2 6 10/230-8 5 PC2 L2 L2 10/230-8 Measured oil pressure Operation of lever Ratio of oil pressures Pump discharge pressure Arm IN relief 1 PC valve output pressure Approx. 0.6 (Approx. 3/5)