Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in pump PC control circuit

UEN00228-00 30 Testing and adjusting PC valves (7) and (8) according to the proce- dure shown below. PC240-8 q As the working load increases, the engine speed lowers remarkably. q The engine speed is normal but the work equipment speed is low. q (7): Front pump PC valve q (8): Rear pump PC valve a The width across flats of the PC valve locknut is 13 mm and that of the adjustment screw (inside width) is 4 mm. Do not turn any other locknuts or adjustment screws since they affects the hydraulic pump performance. 3) Start the engine and set the working mode in the power mode (P).

4) Run the engine at high idle and low idle, set all the levers and pedals for work equipment control, swing control, and travel in neutral, and measure the oil pres- sure at each speed. PC240-8 a Measuring condition and method of judgment: If the output pressures are in the following ratio, the PC-EPC valve is normal. 5) After finishing measurement, remove the measuring tools and return the removed parts. Adjusting Adjusting pump PC valve a If either of the following phenomena occurs and the PC valve seems to be defective, adjust 34 PC210, 230, 240-8 PC2 8 10/230-8 7 Engine Operation of lever Output pressure Low idle All control levers and pedals in neutral Approx. 2.9 MPa {Approx.

30 kg/cm2} High idle 0 MPa {0 kg/cm2}