Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in pump LS control circuit

UEN00228-00 30 Testing and adjusting Measuring and adjusting oil pressure in pump LS control circuit 1 a Measuring and adjusting tools for oil pressure in pump LS control circuit k Stop the machine on a level ground and lower the work equipment to the ground. Then, release the residual pressure from the hydraulic circuit. For details, see “Releasing residual pressure from hydrau- lic circuit”. PC240-8 Measuring a Before measuring the oil pressure in the PC control circuit, check that the oil pressure in the work equipment, swing, and travel circuits and the basic pressure of the control circuit are nor- mal.

a Measure the oil pressure in the pump LS con- trol circuit under the following condition. 2) Install nipples M3 and nipples [1] of hydraulic tester M1 and connect them to oil pressure gauges [2]. a Connect the measuring part of plug (3) by using joint (790-301-1271) and elbow (790-301-1530) of hydraulic tester M1 and nipple [1] so that it will not interfere with the drain piping. a Use the oil pressure gauges of 58.8 MPa {600 kg/cm 2 }. q Hydraulic oil temperature: Within operating range 1. Measuring LS valve output pressure (servo piston inlet pressure) a Measure the LS valve output pressure (servo piston inlet pressure) and pump discharge pressure simultaneously and compare them.

1) Open the side cover of the pump room and remove oil pressure pickup plugs (1), (2), (3), and (4). q (1): Front pump discharge pressure pickup plug q (2): Rear pump discharge pressure pickup plug q (3): Front LS valve output pressure pickup plug q (4): Rear LS valve output pressure pickup plug 36 PC210, 230, 240-8 PC2 4 10/230-8 1 2 Warning:Test points revers on PC210/230-8 pump 3 ed Symbol Part No. Part name M 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 799-401-2701 Differential pressure gauge 3 799-101-5220 Nipple (10 × 1.25 mm) 07002-11023 O-ring PC21 M3 M3 0/230-8 M3 1