Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in pump LS control circuit

30 Testing and adjusting UEN00228-00 a Measuring condition and method of judgment: If the pressures are in the following ratio, the LS valve is normal. PC240-8 3) Start the engine and push up the track shoe on the side to be measured with the work equipment and prepare for running the track shoe idle. 6) After finishing measurement, remove the measuring tools and return the removed parts. 2. Measuring LS differential pressure a Measure the pump discharge pressure and LS pressure (actuator load pressure) simultaneously and calculate the differ- ence between them. 1) Open the side cover of the pump room and remove oil pressure pickup plugs (1), (2), (5), and (6).

q When measuring front circuit: Right track shoe q When measuring rear circuit: Left track shoe k Since the raised track shoe will be run idle during measurement, secure a sufficient working area. 4) Set the working mode in the power mode (P) and set the travel speed in the High position. 5) Run the engine at high idle, set all the levers and pedals for work equipment con- trol, swing control, and travel in neutral, and measure the oil pressure at each speed. Then, operate the travel lever to run the track shoe idle and measure the oil pressure. q (1): Front pump discharge pressure pickup plug q (2):

Rear pump discharge pressure pickup plug k While checking the safety around the machine extremely, run the track shoe pushed up idle. a Do not operate the travel lever to the stroke end (but stop it halfway). PC240-8 PC210, 230, 240-8 37 Measured oil pressure p Operation of lever and ratio of oil pressures All control levers and edals in neu tral Travel lever moved half- - way (Track shoe run idle) Pump discharge pressure LS valve output pressure Almost same 1 Approx. 0.6 (Approx. 3/5) PC2 10/230-8 2 1 Warning:Test points rever on PC210/230-8 pump sed