Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in pump LS control circuit

UEN00228-00 30 Testing and adjusting q (5): Front LS pressure pickup plug q (6): Rear LS pressure pickup plug PC240-8 PC240-8 q The figure shows the LS pressure side. 2) Install nipples M3 and connect it to differ- ential pressure gauge M2 or the oil pres- sure gauge of hydraulic tester M1 . a When using differential pressure gauge M2 : Connect the pump discharge pres- sure to the high pressure side (back side) and connect the LS pressure to the low pressure side (lower side). Since the differential pressure gauge needs a 12V power source, connect it to a battery. a When using oil pressure gauge (in M1 ):

Use the oil pressure gauge of 58.8 MPa {600 kg/cm 2 } having the unit of 0.98 MPa {10 kg/cm 2 }. Since the dif- ferential pressure is about 3.9 MPa {40 kg/cm 2 } at maximum, measure it by installing the same gauge to the pickup plugs alternately. PC240-8 q The figure shows the pump discharge pressure side. 38 PC210, 230, 240-8 P C210/230-8 3 M M 3 M 3 PC21 0/230-8 5 6 PC210/230-8 M3 M3