30 Testing and adjusting UEN00228-00 3. Measuring LS-EPC valve output pressure 1) Open the side cover of the pump room and remove oil pressure pickup plug (7). 3) Run the engine, push up the track shoe on the side to be measured with the work equipment, and prepare for running track shoe idle. q When measuring front circuit: Right track shoe k Since the raised track shoe will be run idle during measurement, secure a sufficient working area. 4) Set the working mode in the power mode (P) and set the travel speed in the High position.
5) Run the engine at high idle, set all the levers and pedals for work equipment con- trol, swing control, and travel in neutral, and measure the oil pressure at each speed. Then, operate the travel lever to run the track shoe idle and measure the oil pressure. q When measuring rear circuit: Left track shoe PC240-8 k While checking the safety around the machine extremely, run the track shoe pushed up idle. a Do not operate the travel lever to the stroke end (but stop it halfway). 2) Install nipple M3 and connect them to oil pressure gauge [2]. a Use the oil pressure gauges of 5.9 MPa {60 kg/cm 2 }. a Measuring condition and method of judgment:
If the pressures are in the following ratio, the LS valve is normal. 6) After finishing measurement, remove the measuring tools and return the removed parts. PC210, 230, 240-8 39 PC21 0/230-8 7 M3 PC210/230-8 Operation of levers LS differential pressure All control levers and pedals in neutral Specified LS dif- ferential pres- sure (See standard values table) Travel lever moved halfway (Track shoe run idle)