UEN00228-00 30 Testing and adjusting 3. Measuring oil leakage from bucket cylinder 1) Move the bucket cylinder to the CURL stroke end and stop the engine. 4. Measuring oil leakage from swing motor 1) Disconnect 2 drain hoses (4) and block the hose side with plugs. a Use the following parts to block the hose side. 07376-70522 (Plug #05) k Release the residual pressure from the piping on the bucket cylinder head side. For details, see Releas- ing residual pressure from hydrau- lic circuit (Operate the lever in the bucket CURL direction only, how- ever). 2) Disconnect hose (3) on the cylinder head side and block the hose side with a flange.
k Take care not to disconnect the hose on the cylinder bottom side. a Use the following part to block the hose side. 07379-00640 (Flange #06) 2) Turn the swing lock switch ON. 3) Run the engine at high idle and relieve the swing circuit by swinging. a Start measuring the oil leakage 30 seconds after relieving is started and measure for 1 minute. a After measuring 1 time, swing 180°, and then measure again. 4) After finishing measurement, return the removed parts. 3) Run the engine at high idle and relieve the bucket circuit by curling the bucket. k Take care not to “dump the bucket”. 4) Start measuring the oil leakage 30 sec- onds after relieving is started and mea- sure for 1 minute.
5) After finishing measurement, return the removed parts. 52 PC210, 230, 240-8