Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Bleeding air from each part

UEN00228-00 30 Testing and adjusting 3) While running the engine at high idle, per- form step 2). 4) While running the engine at low idle, move the piston rod to the stroke end and relieve the oil. 5) Bleed air from the arm cylinder and bucket cylinder according to steps 2) – 4). 2) Check the oil level by sight gauge (3) on the rear side of the hydraulic tank. a If the oil level is below line L, it is insufficient. Add oil. a The oil level changes according to the oil temperature. Add oil when the oil level is out of the following standard ranges. 4. Bleeding air from swing motor 1) Run the engine at low idle. 2) Swing slowly to bleed air. q When oil temperature is 10 – 30°C:

Between line H and line L q When oil temperature is 50 – 80°C: Near line H 5. Bleeding air from travel motor 1) Run the engine at low idle. 2) Loosen air bleeder (2) and check that oil oozes out through the air bleeder. 3) After the oil oozes out, tighten air bleeder (2). 3 Air bleeder: 27.5 – 35.3 Nm {2.8 – 3.6 kgm} 6. Checking oil level and starting work 1) Run the engine, retract the arm cylinder and bucket cylinder to the stroke ends, lower the work equipment to the ground, and stop the engine. 56 PC210, 230, 240-8