30 Testing and adjusting UEN00229-00 Cylinder Cut-Out operation The operator can perform "Cylinder Cut-Out" oper- ation with the machine monitor. "Cylinder Cut-Out" operation means to run the engine with 1 or more fuel injectors disabled electri- cally to reduce the number of effective cylinders. This operation is used to find out a cylinder which does not output power normally (combustion in it is abnormal). 1. Selecting menu Select "Cylinder Cut-Out" on the service menu screen. 3. Resetting Cut-Out cylinder When changing a cylinder to be Cut-Out or when Cylinder Cut-Out operation is finished, select a Cut-Out cylinder to be reset with the function switches.
a This operation may be performed while the engine is running. a When [F6] is pressed, if background (a) of the selected cylinder No. becomes blue, the cylinder is reset. a The Cut-Out operation is not automatically reset after the screen returns to the opera- tor mode. Accordingly, be sure to perform the resetting operation after the cylinder cut-out operation is finished. 2. Selecting cylinder to be disabled After the "Cylinder Cut-Out" screen is dis- played, select a cylinder to be Cut-Out with the function switches. q [F1]: Move selection mark ( R ) to left 4.
Function of holding displayed information If [F4] is pressed during the cylinder Cut-Out operation, the displayed information is newly held (c) (The real-time information is kept dis- played on the left side). While the information is held, if [F3] is pressed, the holding function is reset. a The holding function is effective, regard- less of setting of the reduced cylinder mode operation. q [F2]: Move selection mark ( R ) to right q [F3]: Reset holding q [F4]: Hold q [F6]: Confirm selection a This operation may be performed while the engine is running. a When [F6] is pressed, if background (a) of the selected cylinder No. becomes white, the cylinder is Cut-Out.
a If the machine monitor Cut-Out a cylinder but the engine controller cannot Cut-Out that cylinder, the background of the cylin- der No. becomes yellow. a If the machine monitor resets a Cut-Out cylinder but the engine controller cannot reset that Cut-Out cylinder, the back- ground of the cylinder No. becomes red. a One or more cylinders can be Cut-Out. a In the cylinder Cut-Out operation, the auto-deceleration function can be selected. If the auto-deceleration is turned ON, auto-deceleration monitor (b) is dis- played. q [F5]: Return to service menu screen PC210, 230, 240-8 49