UEN00229-00 30 Testing and adjusting [Reference] No injection cranking If the engine is operated after long storage of the machine, it may be worn or damaged because of insufficient lubrication with oil. To prevent this, the function to lubricate the engine before starting it by cranking it without injecting fuel is installed. Set the no-injection cranking while the engine is stopped. q If a normally operating cylinder is Cut-Out, the following phenomena occur. 1) Lowering of engine speed 2) Increase of final injection rate com- mand (quantity) q If the engine is running near the high idle, however, the engine speed may not lower for the reason of engine control.
q In this case, lower the engine speed with the fuel control dial and judge by increase of the injection rate command. 1. Selecting menu Select "No injection" on the service menu screen. 2. Displaying check screen If the "No injection" screen is displayed, the machine monitor asks the operator if no injec- tion cranking should be performed. Answer with the function switch. q [F5]: Do not perform (Return to Service menu screen) q [F6]: Perform a While the screen is changing to the follow- ing screen, the screen of "Communication between controllers is being checked" is displayed. 50 PC210, 230, 240-8