Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Preparation work for troubleshooting of electrical system

30 Testing and adjusting UEN00230-00 7) Connect troubleshooting T-adapters to con- nectors CK01 and CK02 of KOMTRAX communication module (13). a Cable (14) is for the communication antenna. a Removal and installation of sensor A deep socket is necessary for removal and installation of the engine oil pressure switch. See "Tools for testing, adjusting, and troubleshooting". 6. Boost pressure and temperature sensor (BOOST PRESS & IMT) a Disconnection and connection of con- nector The connector of the boost pressure and temperature sensor has a special locking mechanism. Disconnect it according to steps (a) – (b) and connect it according to steps (c) – (d) as shown below. Disconnection :

(a) Unlock – (b) Discon- nect connector. Connection : (c) Connect connector – (d) Lock. 5. Atmospheric pressure sensor (AMBAIR PRESSURE) Engine Ne speed sensor (CRANK SENSOR) Engine Bkup speed sensor (CAM SENSOR) Engine oil pressure switch (OIL PRESSURE SWITCH) a Disconnection and connection of con- nectors The connectors of the atmospheric pres- sure sensor, engine Ne speed sensor, engine Bkup speed sensor, engine oil pressure switch have a special locking mechanism. Disconnect them according to steps (a) – (c) and connect them according to steps (d) – (f) as shown below. Disconnection : (a) Slide lever – (b) Unlock – (c) Disconnect connector. Connection :

(d) Connect connector – (e) Lock – (f) Slide lever. a Removal and installation of sensor A torque wrench is necessary for removal and installation of the boost pressure and temperature sensor. See "Tools for test- ing, adjusting, and troubleshooting". PC210, 230, 240-8 5