40 Troubleshooting UEN00240-00 Failure code [B@BCNS] Eng Water Overheat 1 Failure code [B@BCZK] Eng Water Level Low 1 PC210, 230, 240-8 19 User code Failure code Trouble Engine coolant overheat (Engine controller system) — B@BCNS Contents of trouble • While engine was running, signal circuit of engine coolant temperature sensor detected overheating of engine coolant (above about 102°C). Action of controller • Displays engine coolant temperature monitor with red on machine monitor. • If cause of failure disappears, system resets itself. Problem that appears on machine • If machine is operated as it is, engine may be seized.
Related infor- mation • Engine coolant temperature sensor signal is input to engine controller and then transmitted to machine monitor. • Engine coolant temperature can be checked with monitoring function (Code: 04107 Engine coolant temperature) • Method of reproducing failure code: Start engine. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Overheating of engine coolant (when system is nor- mal) Engine coolant may be overheating. Check it and remove cause if it is overheating. 2 Defective engine coolant temperature gauge system If cause 1 is not detected, engine coolant temperature gauge sys- tem may be defective.
Carry out troubleshooting for "E-9 Engine coolant temperature gauge does not work normally" in E-mode. User code Failure code Trouble Engine coolant level low (Machine monitor system) — B@BCZK Contents of trouble • When starting switch is turned ON (but engine is not started), signal circuit of radiator coolant level sensor detected low radiator coolant level (sensor contact opened). Action of machine monitor • Displays radiator coolant level monitor on machine monitor. • If cause of failure disappears, system resets itself. Problem that appears on machine • If machine is operated as it is, engine may overheats.
Related infor- mation • Condition of radiator coolant level switch can be checked with monitoring function (Code: 04500 Monitor input 1) • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Lowering of radiator coolant level (when system is nor- mal) Radiator coolant level may be low. Check it and add coolant if it is low. 2 Defective radiator coolant level monitor system If cause 1 is not detected, radiator coolant level monitor system may be defective.
Carry out troubleshooting for "E-2 Basic check item lights up when starting switch is turned ON (but engine is not started)" in E-mode.