Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of engine rear seal

50 Disassembly and assembly UEN00660-00 Installation 1. Install the oil seal according to the following procedure. a Do not remove pilot [5] which is attached to oil seal (5) until oil seal (5) is inserted to the crankshaft. a Before installing the oil seal, de-grease, clean and dry the crankshaft sealing face and the seal lip face to prevent oil leak- age. 2. Insert pilot [5] to crankshaft (6) and push oil seal (5) into flywheel housing (7). 3. Push in oil seal (5) further and pull out pilot [5]. 4. Install oil seal (5) on flywheel housing (7) to the proper depth by using tool A2 . a Push in oil seal (5) taking care that there are no bend etc. on it.

a Extrusion of oil seal (5) from flywheel housing (7) X : less than 0.38 mm PC210, 230, 240-8 15