UEN00660-00 50 Disassembly and assembly q Carry out the rest of installation in the reverse order to removal. 4) As in the case of measurement of radial run out, bring the dial gauge probe into contact with end surface b near the outer perimeter of the flywheel at a right angle. a Conduct measurement pulling the crankshaft to either the front or rear side to prevent errors caused by shakiness. 5) Rotate the flywheel 360° and measure the difference of the maximum swing of the dial gauge indicator. [*1] a Tighten the eight flywheel mounting bolts in the order of (1) through (8) as shown in the figure below. 3 Flywheel assembly mounting bolt:
137 ± 7 Nm {13.97 ± 0.71 kgm} a Tighten the bolts using bar [3] for preventing rotation of the flywheel assembly. q Measurement of radial run out a Radial run out: less than 0.13 mm 1) Set dial gauge [4] to the stand, and set it to flywheel housing (7). 2) Bring the dial gauge probe into contact with faucet joint portion a or the outer perimeter surface of the flywheel at a right angle. 3) Rotate the flywheel 360°and measure the difference of the maximum swing of the dial gauge indicator. a Check that the dial gauge indicator is back in the original position after the flywheel is rotated 360°. q Measurement of facial run out a Facial run out: less than 0.20 mm 16 PC210, 230, 240-8