50 Disassembly and assembly UEN00660-00 Installation q How to tighten mounting bolts (60) 1. Cylinder head assembly 1) Measure under head length a of all the cylinder head mounting bolts to check that they are within the length limit. a Tighten the bolts in the order shown below. 1] 90 ± 3 Nm {9.2 ± 0.3 kgm} 2] Recheck the torque: 90 ± 3 Nm {9.2 ± 0.3 kgm} . 3] 90° ± 5° (Tighten with an angle tight- ening tool.) a Tool A6 : wrench is adopted for angle tightening. (Refer to the tool list.) (Refer to the tool list.) q Bolt length limit: less than 132.1 mm a If a bolt is longer than the using limit, do not reuse it but replace it. a Tool A7 : gauge is adopted for the measurement.
(Refer to the tool list.) 2) Set head cylinder gasket (62) after check- ing that there is no dust or foreign material on the cylinder head mounting face and inside the cylinders. a Check that the gasket is properly matched with the cylinder head holes. 3) Set cylinder head assembly (61) on the cylinder block, screw in mounting bolts (60) by hand a few turns, and tighten them according to the following procedure. q When an angle tightening tool is not used: Put marks on the cylinder head and bolts with a felt-tip pen, and then tighten the bolts an additional 90° ± 5° . 2 : Coat the threads and seat surface of the mounting bolts with engine oil (EO15W-40) . PC210, 230, 240-8 23