Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of cylinder head assembly

UEN00660-00 50 Disassembly and assembly 3 Mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} 3. Install push rods (57). 4. Install rocker arm support (58). 2. Install rocker housing assembly (59). 4) Assemble fuel injector assembly (56) to the cylinder head with its fuel inlet hole facing the intake manifold side. 5) Tighten bolts (55) three or four turns. 6) Coat the head side (B part) of inlet con- nector (54) with engine oil (EO15W-40). 7) Coat O-ring (C) of inlet connector (54) with engine oil (EO15W-40). Then insert inlet connector (54) completely, aligning (D part) with the side groove of the head. 5. Fuel injector assembly a Check that there is no damage or dust on the fuel injector sleeve.

1) Install O-ring (63) and gasket (64) to fuel injector (62). 2) Coat O-ring (63) and the head side of fuel injector (62) with engine oil (EO15W-40). 8) Tighten inlet connector (54) with retainer (53) by hand. (Push it into the injector hole.) 9) Tighten mounting bolts (55) for fuel injec- tor assembly (56) alternately. 2 O-ring (63) and the head side of fuel injector (62): engine oil (EO15W-40) 3) Install holder (65) to fuel injector (62) with concavity and convexity (A) fitted together. 3 Bolt: 8 ± 0.8 Nm {0.81 ± 0.08 kgm} 10) Tighten retainer (53). 3 Retainer: 50 ± 5 Nm {5.1 ± 0.5 kgm} 24 PC210, 230, 240-8