Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Removal and installation of cylinder head assembly

50 Disassembly and assembly UEN00660-00 6. Rocker arm and crosshead assembly 1) Install rocker arm and crosshead assem- bly (52). a When reusing the crosshead, install the same intake and exhaust valves in the same direction because the shapes of its holes a and b are differ- ent, a Tighten the mounting bolt after check- ing that the ball portion of adjustment screw (51) is well seated in the push rod socket. 7. Install harnesses (49). a Harness installation position Harness color Cylinder No. White 1, 3, 5 3 Mounting nut: 1.5 ± 0.25 Nm {0.15 ± 0.03 kgm} Black 2, 4, 6 3 Mounting bolt: 36 ± 5 Nm {3.7 ± 0.5 kgm} 2) Adjust the valve clearances.

a Refer to the Adjusting of Valve Clear- ance section in the TESTING AND ADJUSTING chapter of this manual. 3 Locknut (50): 24 ± 4 Nm {2.4 ± 0.4 kgm} 8. Fit the O-ring and install head cover (48). 3 Mounting nut: 24 ± 4 Nm {2.4 ± 0.4 kgm} 9. Install blow-by duct (45). 3 Blow-by duct mounting bolt: 10 ± 2 Nm {1.0 ± 0.2 kgm} 10. Install fuel drain hose (46). 3 Joint bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} PC210, 230, 240-8 25