50 Disassembly and assembly UEN00660-00 [*9], [*10] a Coat the two bolt threads on the inner side of the engine with sealant (LG- 7). q High-pressure pipes and common rail k Do not use high-pressure pipes with bend- ing modification. 3 Mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} 7) Install bellows (23) to each high-pressure pipe. (14 pieces) a Set the slits of each bellows out and down. a The bellows are installed so that fuel will not spout over the hot parts of the engine and catch fire when it leaks for some reason. a FSP: Fuel supply pump k Be sure to use a genuine high-pressure pipe fixing clamp and observe strictly the tightening torque.
a A high-pressure pipe which has depressions such as visible vertical slit scar (b), patchy scars (c) etc. on the taper seal section of its connector ((a) part: within 2 mm from the tip), or a high- pressure pipe whose (d) part (end of the taper seal section: 2 mm from the tip) catches on a fin- ger nail due to fatigue, may cause fuel leakage. In these cases, replace the high-pressure pipe. 1) Assemble common rail (25) and high- pressure pipes (71) – (76) temporarily. 3 Sleeve nut and mounting bolt: 0.2 – 0.8 Nm {0.02 – 0.08 kgm} 2) Tighten high-pressure pipes (71) – (76) according to the following procedure. 3 Sleeve nut:
35 ± 3.5 Nm {3.6 ± 0.4 kgm} 1] Head side of high-pressure pipes (71) and (76) 2] Common rail side of high-pressure pipes (76) and (71) 3] Head side of high-pressure pipes (72), (73), (74) and (75) 4] Common rail side of high-pressure pipes (72), (73), (74) and (75) 3) Tighten the sleeve nut of high-pressure pipe (22) temporarily. 4) Tighten high-pressure pipe (22) in the order of firstly pump (FSP) side, then com- mon rail (25) side. [*11] 3 Air tube clamp: 10.0 – 11.0 Nm {1.02 – 1.12 kgm} [*12] q MIKALOR clamp a Reference Length of insertion: 40 mm (turbocharger side) a Refer to [*3]. 3 Sleeve nut: 35 ± 3.5 Nm {3.6 ± 0.4 kgm} 5) Tighten clamp (21) of high-pressure pipe (22).
[*13] 3 Lubrication inlet hose tightening nut: 35 ± 5 Nm {3.5 ± 0.5 kgm} 3 Mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} 6) Tighten common rail (25) with four bolts. 3 Lubrication outlet hose mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} PC210, 230, 240-8 27