UEN00661-00 50 Disassembly and assembly 12. Hub assembly 1) Use an eyebolt [2] to remove hub assem- bly. a PC230-8, PC240LC-8, PC240NLC-8 Assembly a Clean the parts completely and inspect them for any foreign material or damage. Apply power train oil ( TO30 ) on the sliding surfaces before assembly. 1. Travel motor assembly 1) Set floating seal (31) to the tool J5 . a Install floating seal with the O-ring and O-ring contact surface de- greased and dried completely. 2) Disassemble hub assembly in the follow- ing procedure. 1] Remove floating seal (27). 2] Remove ball bearings (28) and (29) from hub (30). 2) Install floating seal (31) to travel motor (32).
a After the floating seal installation, check that the inclination of the seal is 1 mm or less. a After floating seal installation, check the sliding surfaces for any foreign material and then apply a thin coat of power train oil (TO30) on it. 13. Travel motor assembly Remove floating seal (31) from travel motor (32). 14 PC210, 230, 240-8