Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

50 Disassembly and assembly UEN00661-00 2. Hub assembly 1) Assemble hub assembly in the following procedure. 1] Use push tool to press fit ball bear- ings (29) and (28) into hub (30). 2) Use an eyebolt [2] to set hub assembly (26) to travel motor. a When hub assembly is difficult to install, install it by lightly tapping the bearing inner race with push tool. 2] Set floating seal (27) to the tool J5 . a Install floating seal with the O- ring and O-ring contact surface de-greased and dried completely. 3] Install floating seal (27) to hub (30). a After the floating seal installation, check that the inclination of the seal is 1 mm or less.

a After floating seal installation, check the sliding surfaces for any foreign material and then apply a thin coat of power train oil (TO30) on it. 3. Locked 1) Use tool J6 to press the inner race of the ball bearing. q Specified pressing force: 8.8 – 12.7 kN {0.9 – 1.3 ton} 2) Rotate hub assembly (26) 2 – 3 times with the bearing pressed. 3) With this condition, measure size (a) from the top surface of travel motor to the top surface of the bearing inner race. a When measurement is complete, remove tool J6 . 4) Measure the thickness (b) of the lock (25) as a unit. 5) Calculate the screwing depth (c) using the measurements (a) and (b). q c = a – b – (0 – 0.1) PC210, 230, 240-8 15