Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

UEN00661-00 50 Disassembly and assembly 6) Using the tool J4 , screw in the lock (25) to the calculated depth (c). a The screwing depth (c) is the size between the top surface of the travel motor and the top surface of the lock. 4. No.2 carrier assembly 1) Assemble No. 2 carrier assembly in the following procedure. 1] Assemble thrust washer (23), needle bearing (22), No. 2 planetary gear (21), and thrust washer (20) into car- rier (19). a If the disassembled carrier is reused, recover the staking remaining on the pin hole (d) in the carrier in advance. a Replace thrust washer with new one. 7) Use push-pull scale [3] to measure the tangential force (starting force) of hub assembly.

a The location for tangential force (starting force) measurement is the bolt hole for the sprocket mounting bolt. q Tangential force (starting force): 294 N or less {30 kg or less} a If the tangential force (starting force) is not normal, disassemble again to find the cause. 8) Install lock (24). 2 Mounting bolt: Liquid adhesive (LT-2) a Do not apply the liquid adhesive to the screw hole in the lock. a Install the lock so that it is in full con- tact with the travel motor spline. 16 PC210, 230, 240-8