Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

50 Disassembly and assembly UEN00661-00 2] Install pin (18). a Align the pin hole and the hole in the carrier before pin is com- pletely inserted. a When installing the shaft, be careful not to damage thrust washer while rotating the plane- tary gear. 3] Install pin (17). a Replace pin with new one. a Before inserting the pin, check the orientation so that the 3 pawls (e) on the outer circumfer- ence of the pin do not seat on the thin portion of the carrier. a After inserting the pin, stake at 2 locations around the pin hole to prevent the pin from coming out. a When assembling of the No. 2 carrier assembly is complete, check that all gears rotate smoothly. 5. Washer Install washer (15). 6.

No. 2 sun gear Install No. 2 sun gear (14). 7. Thrust washer Install thrust washer (13). 8. No. 1 sun gear shaft Install No. 1 sun gear shaft (11). 9. No.1 & No.2 ring gears 1) Install O-ring to the hub. 2) Use an eyebolt [4] to install No. 1 & No. 2 ring gears (12) to hub. a De-grease the mating surfaces of the ring gear and the hub, and do not apply liquid gasket on the mating sur- faces. a Align the holes in the ring gear and the hub. 2) Install No. 2 carrier assembly (16). a Align the 4 lower ends of the pin in No. 2 carrier assembly with the 4 dim- ples in the motor case. PC210, 230, 240-8 17