Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of final drive assembly

UEN00661-00 50 Disassembly and assembly 10. No.1 carrier assembly 1) Assemble No. 1 carrier assembly in the following procedure. 1] Assemble thrust washer (10), needle bearing (9), No. 2 planetary gear (8), and thrust washer (7) into carrier (6). a If the disassembled carrier is reused, recover the staking remaining on the pin hole (g) in the carrier in advance. a Replace thrust washer with new one. 2) Install No. 1 carrier assembly (3). a Check that all gears are smoothly in mesh. If the meshing is not proper, shake the hub in the rotation direction several times to properly mesh them. 11. Washer Install washer (2).

a After washer installation, measure the size (j) from the top surface of the washer to the top end surface of the ring gear to check the condition of assembly. a Gears are properly assembled if the size (j) is 19 mm or less. 2] Install pin (5). a Align the pin hole and the hole in the carrier before pin is com- pletely inserted. a When installing the shaft, be careful not to damage thrust washer while rotating the plane- tary gear. 3] Install pin (4). a Replace pin with new one. a Before inserting the pin, check the orientation so that the 3 pawls (h) on the outer circumfer- ence of the pin do not seat on the thin portion of the carrier.

a After inserting the pin, stake at 2 locations (i) around the pin hole to prevent the pin from coming out. a When assembling of the No. 1 carrier assembly is complete, check that all gears rotate smoothly. 18 PC210, 230, 240-8