UEN00663-00 50 Disassembly and assembly Disassembly and assembly of center swivel joint assembly 4. Using tool T1 , pull out swivel shaft (7) from swivel shaft (8). Special tools 5. Remove seal (9) and O-ring (10) from swivel rotor (7). 6. Remove dust seal (11) from cover (12). Assembly a See figure at left. Disassembly 1. Install seal (9) and O-ring (10) to swivel rotor (7). 2. Install dust seal (11) to cover (12). 3. install cover (12) to swivel shaft (8). 4. Set swivel shaft (8) to block, then using push tool, tap swivel rotor (7) with a plastic hammer to install. 2 Contact surface of rotor, shaft:
Grease (G2-LI) a When installing rotor, be extremely careful not to damage the dust seal and O-ring. 5. Install ring (6) and fix with snap ring (5). 6. Fit O-ring and install cover (4). 3 mounting bolts: 31.4 ± 2.9 Nm {3.2 ± 0.3 kgm} 7. Install elbow (1), (2) and tee (3). 3 Elbow (1): 128 – 186 Nm {13 – 19 kgm} 3 Elbow (2), tee (3): 35 – 63 Nm {3.2 – 6.5 kgm} 1. Remove elbow (1), (2) and tee (3). 2. Remove cover (4). 3. Remove snap ring (5) and ring (6).
4 PC210, 230, 240-8 Symbol Part number Part name Necessity Q’ty N/R Sketch T1 790-101-2501 Push puller q 1 • 790-101-2510 • Block 1 • 790-101-2520 • Screw 1 • 791-112-1180 • Nut 1 • 790-101-2540 • Washer 1 • 790-101-2630 • Leg 2 • 790-101-2570 • Plate 4 • 790-101-2560 • Nut 2 • 790-101-2650 • Adapter 2