Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of hydraulic cylinder assembly

50 Disassembly and assembly UEN00663-00 3. Disassembly of cylinder head assembly 1) Remove O-ring and backup ring (15). 2) Remove snap ring (16) and then remove dust seal (17). 3) Remove rod packing (18). 4) Remove buffer ring (19). 5) Remove busing (20). 2. Disassembly of piston assembly 1) Using tool U3 , expand piston ring (13). a Set the piston ring on tool U3 , and turn the handle 8-10 times to expand the ring. 2) Set tool U4 , and compress piston ring (13). Assembly a Be careful not to damage the packing, dust seals, and O-rings. a Clean each part, then cover the piping ports and pin-inserting hole to prevent dust from entering them. a Do not try to force the backup ring into position.

Warm it in warm water (50 – 60°C) before installing it. 1. Disassembly of recoil spring assembly 1) Using tool U5 , press fit bushing (20). 2) Assemble buffer ring (19). 3) Assemble rod packing (18). 4) Using tool U6 , install dust seal (17), and secure with snap ring (16). 5) Install the backup ring and O-ring (15). 3) Install the backup ring and O-ring (14). 4) Assemble wear ring (12). 5) Assemble ring (11). a Be careful not to open the end gap of the ring too wide. 2 Ring groove: Grease (G2-LI) PC210, 230, 240-8 27