Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Disassembly and assembly of hydraulic cylinder assembly

UEN00663-00 50 Disassembly and assembly a Put a mark on the end face of the rod so that the processing hole position of cap (8) is visual from outside. q Arm cylinder only 3. Piston rod assembly 1) Set piston rod assembly (2) in tool U1 . 6) Assemble piston assembly (4) as follows. q When using piston rod assembly (2) and piston assembly (4) again a Wash thoroughly and remove all metal particles and dirt. 1] Screw in piston assembly (4) by using tool U2 , and tighten piston assembly (4) until the position of the screw thread hole (H1) which is in piston rod assembly (2) halfway matches. a Remove all burrs and flashes on the threaded portion with a file. 2) Assemble head assembly (7).

3) Fit O-ring and backup ring to collar (6), then assemble. q Boom and arm cylinder only 4) Assemble plunger (5). q Boom and arm cylinder only 5) Set plunger (10) on the piston rod, assem- ble 12 balls (9) to it and secure with cap (8). a Check that there is a small amount of play at the tip of the plunger. 28 PC210, 230, 240-8