50 Disassembly and assembly UEN00663-00 2] Machine one of the hole used to install screw (3). a Align a drill horizontal with the V- groove of the thread of piston rod assembly (2) and piston assembly (4), then carry out machining. a For the arm cylinder, avoid the cap machining holes position when machining. (See step 3.5.) 2] Tighten screw (3). 2 Screw part female screw side: Loctite No.262 3 Screw: 58.9 – 73.6 Nm {6 – 7.5 kgm} 3] Caulk thread at four places (a) of screw (3) with punch. q Screw machining dimension (mm) 3] After machining, wash thoroughly to remove all metal particles and dust. 4] Tighten screw (3). 2 Screw part female screw side:
Loctite No.262 When using a new part for either or both of piston rod assembly (2) and piston assembly (4) 3 Screw: 58.9 – 73.6 Nm {6 – 7.5 kgm} 5] Caulk thread at four places (a) of screw (3) with punch. a For the rod with bottom cushion, mark the cap position on the end surface of rod. (See step 3.5.) q Arm cylinder only 1] Screw in until piston assembly (4) contacts end surface (B) of rod, then use tool to tighten. 3 Piston assembly: 294 ± 29.4 Nm {30 ± 3.0 kgm} a After tightening the piston, check that there is play in plunger (5). q Boom, arm cylinder only 7) Set piston rod assembly (2) in tool U1 .
PC210, 230, 240-8 29 Bottom hole drill diameter Bottom hole dep Tap used T th ap depth 10.3 24 12x1.75 20