Komatsu — CHECK AND ADJUST TRACK TENSION

. MAINTENANCE MAINTENANCE PROCEDURE CHECK AND ADJUST TRACK TENSION WARNING so inspect the Adjustment WARNING 4 - 27 For details on starting the engine an d operating the work equipment, see "BEFORE ST ARTING ENGINE (PAG E 3-58)", "STARTING ENGINE(PAGE3-72)", "AFTER STA RTING ENGINE(PAGE 3-76)", and "WORK EQUIPM ENTCONTROLS AND OPERATIONS (PAGE 3-91)" in the OPERATION section. Wear on pins and bushings of t he undercarriage will vary with working con ditions and type of track tension every now and the n in order to maintain the standard tension. For carrying out inspection and adjustment of track shoes, park the machin e on the flat and sol Checking 1. 2. 3.

Run the engine at low idle, t hen move the machine forward for a distance equal to the track the machine. length on ground, and slowly stop 2. Put on the track shoe straig ht wooden bar (3) which stretches from idler (1) to upper carrie r roller (2). ection between bottom surface of face of the track shoe. - 30 mm (0.4 - 1.2 in). Measure the maximum defl the wooden bar and top sur Deflection "a" should be 10 If the track tension is not at the standard value, adjust it in the following man There is danger of plug (1) flying out under the high internal pressure of the grease. Never loosen plug (1) more than 1 turn. plug (1). Never put your face in the ened with the procedure given here, butor.

Never loosen any part other than mounting direction of plug (1). If the track tension cannot be loos If please contact your Komatsu distri Increasing Track Tension Prepare a grease pump. 1. 2. 3. 1. Pump in grease through gre ase fitting (2) with a grease pump. (Grease fitting (2) forms one part with plug (1).) orrect, run the engine at low idle, 2. To check if the tension is c move the machine slowly fo length of track on ground), t rward (by an amount equal to the hen stop the machine. Check the track tension aga in, and if the tension is not correct, adjust it again.