. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE Loosening Track Tension WARNING 4 - 28 4. Continue to pump i n grease until dimension ( S) becomes zero (0) . If the tension is still loose, the pin a nd bushing are excessively worn, s o they must be either tur ned or replaced. Please contact you r Komatsu distributor for r It is extremely dangerous to release the grease by any method excep t the If track tension is not relie ved by this procedure, conta ct your Komatsu 1. Loosen plug (1) gra dually to release the grea se. of one turn. 2. When loosening plu g (1), turn it a maximum 3. If t he grease does not come out smoothly, m ove the machine 4.
forwards and back Tighten plug (1). wards a short distance. sion is correct, run the engine at low idle, 5. To check if the ten move the machine slowly forward (by an am ount equal to the length of track on g round), then stop the mac hine. 6. Check the track ten sion again, and if the tens ion is not correct, adjust it again. CHECK ELECTRICAL INTAKE AIR HEATE R Before the start of the c old season (once a year) , contact you r Komatsu distributor to have the electrical intake air heater checked for dirt or disconnections.