Komatsu — REPLACE BUCKET TEETH (VERTICAL PIN TYPE)

. MAINTENANCE MAINTENANCE PROCEDURE WARNING 4 - 29 REPLACE BUCKET TEETH (VERTICAL PIN TYPE Replace th e bucket teet h before the adap ter starts to w It replacing Set the w ork equipment in a stable conditio n, stop the engin e, then set lock leve r (1) securely to the LOCK position As the lo cking pin is kno cked out with force, there is danger that the pin may fly o ut. Check that there is no one near the machine. Broken p wear safe ieces may fly ty glasses, glo during the replace ves, or other protec ment operation, tive equipment. 1. To ma ke it possible to knock out pin of tooth (1), pu t block (5) under the bottom o f the bucket, and surfac e of the bucke 2.

Use a hammer and drift to knock out l ock pin (2). (If the drif t is set aga inst rubber pi n lock (3) when it is hit, the rubb er pin l ock may br eak. Set it ag ainst the back of 3. After re moving lock pin (2) and rubber pin lock (3), ch eck them. If lock pin (2) and ru bber pin lock (3) are used in the condition below, it will cause tooth (1) to com operation. Always replace them with new parts. Lock pin (2) is too sh Dimensi on (B) is less than 1/3 A when lock pin (2) is aligned at bottom