Komatsu — REPLACE BUCKET TEETH (VERTICAL PIN TYPE)

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE to come out. 4 - 30 Rubber (6) of the rubber pin lock is cut and the steel ball is about Steel ball (7) sinks in when 4. Clean the surface of adap ter (4) and remove the soil with a knife. 5. Hit rubber pin lock (3) by nd push it into the hole in ad When doing this, be caref from the surface of adapt 6. Clean the inside surface o f tooth (1), then install to adapter (4). it or any protrusion, tooth (1) will not and the fitting contact will be poo ul not to let rubber pin lock (3) fly out 7.

Fit tooth (1) to adapter (4), and confirm that when the pointe r is pressed strongly, the rea teeth (1) is at the same lev pin of the adapter (4). If the rear face of the pin the rear face of the pin hol in. If this happens, there is so from fitting completely in remove the obstruction. adapter (4), knock in lock r face of the hole for the pin of the el as the rear face of the hole for the hole of tooth (1) protrudes in fron t of e of adapter (4), do not knock the pin mething (C) preventing the tooth (1) adapter (4), locate the problem a nd