Komatsu — REPLACE BUCKET TEETH (VERTICAL PIN TYPE)

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE diagram on the right. REMARK replacement. 4 - 31 8. In sert lock pin (2 ) in the pin hole in the to oth (1), and knoc k it in o that the top s urface of lock pin (2) is the same height a s the urface of tooth 9. A fter replacing t he bucket tooth, always check as follows ) After lock pin (2) is completely knoc secured in po sition at tooth (1) and t ) After knockin g in the lock pin (2) fro back lightly in the opposite direction. ) Tap the tip of tooth (1) from the top an d bottom, and the side face from the left and right.

) Rubber pin lo ck (3) and lock pin (2) m ust be as shown i n the If the tooth is turned, the wear will become un iform. This will ex tend the s When replacing the tooth, replace the rubb er pin lock and loc k pin with n prevent the tooth from falling