Engine Tier-3 710655- Ch 1 page 55 10. Machine the valve seat by cranking clockwise while turning the feed screw. Never crank counterclockwise, as this could damage the cutter. Lubricate with cutting oil during the procedure. 11. When the machining of the valve seat is completed, reduce the cutting pressure by turning the crank 23 turns without feeding. Then continue to turn the crank while turning the feed screw anti-clockwise. The valve seat cutter is now ready for the next valve seat. Renewing the valve guides 1. Press out the valve guides using drift 512259. 512259 2. Press in the new valve guides using drift 512258 Press the guide down as far as the drift allows, i.e.
until it makes contact with the spring seat in the cylinder head. 512258 SHOP MANUAL MT26-31 - 06.2005