Engine Tier-3 710655- Ch 1 page 57 Assembly 1. Lubricate all parts well with engine oil before assembly. 2. Fit the valves in the their guides and position the cylinder head in a press. 8406 3. Fit the valve springs and the valve spring collars. 4. Compress the springs using tool 8406 and fit the collets, making sure that they go into their correct positions. Fitting 1. Check liner height, refer to Measuring the cylinder liner height. 2. Fit a new cylinder head gasket. 3. Fit the cylinder head and ensure that the guide pins fit into the holes. 4. The cylinder head bolts can be reused up to 3 times. Therefore, make sure the bolts have no more than 2 punch marks on top of the bolt head.
If any of the bolts has 3 marks, it must be replaced with a new one. 5. Lubricate the threads on the cylinder head bolts and the surface under the head. 6. Tighten the bolts in the order given in the figure and in three stages + 90° as follows: • Tighten all bolts to 60 Nm • Tighten all bolts to 150 Nm • Tighten all bolts to 250 Nm • Finally, tighten all bolts a further 90° • Make a mark with a centre punch on the head of the bolt. 7. Fit the lower part of the rocker cover and tighten the bolts to 26 Nm. SHOP MANUAL MT26-31 - 06.2005