Engine Tier-3 710655- Ch 1 page 64 Adjusting the valve clearance and unit injectors 1. Fit the unit injector according to the section Fitting the PDE injector, steps 1-11. 2. Fit the pushrods. 3. Fit the bearing bracket and torque tighten the bolts to 115 Nm. 4. Fit the valve bridges. Important! Lubricate the valve bridges with engine oil. 5. Continue according to the section: Fitting the PDE unit injector steps 6 - 11 Note: Check and adjust the valve clearance and unit injectors at the same time and with the engine cold. Checking and adjusting the valve clearance: 1. Turn the flywheel with tool 8405 so that the piston in cylinder No. 1 is at TDC after compression. 2.
Check the valve clearance using a feeler gauge and, if necessary, use the adjusting screw on the rocker arm to set the correct clearance. The clearance for intake valves should be 0.45 mm and the clearance for exhaust valves should be 0.70 mm when the engine is cold. The intake valves are actuated by the short rocker arms and the exhaust valves by the long rocker arms. Make sure the valve bridge is resting correctly against the valves. See the table next page. SHOP MANUAL MT26-31 - 06.2005