Doosan Infracore D18NAP — Procedure of Assembling Engine

6. About the engine 1) Align the valve stem seal jig (860104-02041) to CAUTION the valve stem seal (A) and beat it with a rubber Tighten flange hex bolts in the order from (1) - (22). The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. hammer to press it in. CAUTION Do not give an excessive shock on the valve stem seals; otherwise, they may be damaged. 15. Attach the crankshaft pulley. 2) Apply engine oil on the surface where the valves A 3) Attach the valves (B). and the valve stem seals are assembled. CAUTION Be careful to use the right valve without confusing the intake valve with the exhaust valve.

B The intake valve has the larger valve head diameter and the exhaust valve has the smaller one. 17. Attach the valve springs. 1) Align the crankshaft pulley (A) to the pin and EDL013033A attach it. D 2) Apply LOCTITE Blue 587 to the inside of the C 3) Tighten flange hex bolts (B) at a tightening torque flange hex bolts (B). of 26 kgf m. B CAUTION A Be careful not to damage the oil seal. Fix the crankshaft to allow the flange hex bolts to be tightened with the specified torque. EDL013031A 16. Attach the valves. 1) Attach the valve springs (A). A 2) Attach the valve spring retainers (B). 3) Compress the valve with the valve spring 4) Attach the valve cotters (C).

compression tool (EF.120-262). 5) Attach the calipers (D). CAUTION B Check if the valve cotters have been positioned correctly with the plastic hammer after completing attaching them. EDL013032A 6 - 31