6. About the engine 19. Attach the push rods. 21. Attach the cylinder head cover. A A B EDL013029A EDL013027A 1) Apply engine oil on both ends of the push rods. 2) Attach the push rods(A) in the cylinder head holes. 3 10 8 2 3) Hit the head of the push rods with a rubber hammer lightly once or twice to get them positioned in the tappet holes. CAUTION 5 After connecting the push rods, rotate them to check the connection state. 6 20. Attach the rocker arm. 4 9 7 1 EDL013058A 1) Attach the cylinder head cover (A). B 2) Temporarily tighten 10 hex bolts (B) in the order of 3) Tighten 10 hex bolts (B) at a tightening torque of (1) ~ (10). A 0.8 kgf m.
CAUTION Be careful not to allow the seal ring of the cylinder head cover to get out to the outside. Tighten the hex bolts of the cylinder head cover in the order from (1) ~ (10). The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. EDL013028A 1) Attach the rocker arm (A). 2) Tighten 8 flange hex bolts (B) at a tightening torque of 2.2 ± 0.3 kgf m. Do not reuse the cylinder head rubber gasket but replace with new one. 6 - 33