6. About the engine 22. Attach the injectiors. 23. Attach the right and left cylinder head cover. A B B D C D C A EDL013026A EDL013025A 1) Align the injector seal ring washer (A) with the 1) Attach the left cylinder head cover(A). center of the injector hole and mount it. 2) Tighten 10 flange hex bolts (B) at a tightening 2) Sufficiently apply engine oil on the cylinder head cover surface where the injectors contact. 3) Attach the right cylinder head cover (C). torque of 1.0 kgf m. 3) Attach 3 injectors (B). 4) Tighten 8 flange hex bolts (D) at a tightening CAUTION torque of 1.0 kgf m. Do not reuse the head cover rubber seal and the injector oil seal but replace with new ones.
CAUTION Do not reuse the cylinder head cover rubber gasket but replace with new noes. Attach injectors by slowly turning them to prevent damage to the cylinder head cover surface which contacts the injectors. Do not reuse the injector seal ring washers. Otherwise, critical damage to the engine may occur because of unstable combustion. 24. Attach the water pump. 4) Mount 3 injector fixtures (C). B A 5) Temporarily tighten 3 hex bolts (D). CAUTION C Do not tighten the hex bolts by force when it is difficult to tighten them temporarily. Forced tightening may cause damage to the cylinder head. D 6) Tighten 3 hex bolts (D) at a tightening torque of 3.5 kgf m.
EDL013024A 1) Align the gasket(A) with 2 stud bolts and attach it. 2) Align the water pump (B) with 2 stud bolts and attach it. Note) To replace stud bolts, apply LOCTITE 272 to the stud bolts and then press in those bolts. 3) Tighten 4 hex bolts (C) and 2 flange hex nuts (D) at a tightening torque of 2.2 kgf m 6 - 34