6. About the engine 1) Temporarily tighten 2 hex bolts (A) to the exhaust 30. Attach the exhaust manifold pipe (Only TYPE-1). manifold side. 2) Attach the heat screen (B). 3) Tighten 2 fixing bolts (C). 29. Attach the exhaust manifold. C 1 A A B B C D EDL013017A 1) Attach the exhaust manifold pipe (A). 2) Tighten 3 flange hex bolts (B) at a tightening EDL013018A 3) Tighten 3 hex nuts (C) at a tightening torque of 2.2 torque of 4.4 kgf m. 2 kgf m. Note) The exhaust mainfold pipe (A) is only TYPE-1. A B 31. Attach the thermostat. C A C D E EDL013019A B 1) Attach the gasket (A) so that the TOP mark faces D the top surface and the front of the engine. 2) Attach the exhaust manifold (B).
CAUTION EDL013016A Be careful to note the direction in which the gasket is mounted. Mount the gasket so that the TOP mark faces the front of the engine. 1) Attach the thermostat (A) to the cylinder head. 2) Tighten 3 flange hex bolts (B) at a tightening torque of 2.2 kgf m. Be careful not to damage the gasket while mounting it. 3) Tighten the space bolt and the flange hex nut (C) 4) Connect the rubber hose (D). at a tightening torque of 2.2 kgf m. 3) Tighten 6 flange hex bolts (C) at a tightening torque of 3.1 kgf m. 5) Attach the water temperature sensor (E). 4) Attach the exhaust gas temperature sensor (D). 6 - 36