Doosan Infracore D18NAP — Thermostat Disassembly

7. Cooling System Thermostat General Information The thermostat maintains water temperature in the Thermostat Disassembly engine consistently and prevents heat loss to improve heat efficiency of the engine. When the coolant temperature is below the normal CAUTION Detaching the thermostat itself may degrade cooling performance. Do not detach the thermostat itself. temperature, the thermostat is closed and the coolant is bypassed and directly flows into the water pump. When the coolant temperature reaches the normal temperature or is higher than the temperature, the thermostat is fully open and the bypass circuit is closed. So the coolant flows into the radiator. 1.

Drain coolant until the coolant level is below the thermostat height. 2. Remove the thermostat. CAUTION The wax pellet type thermostat shows slower response to the change of cooling water than the bellows type thermostat. This happens because the heat capacity of the wax pellet type thermostat is larger than that of the bellows type thermostat. Therefore, to prevent a rapid increase in the engine coolant’s temperature, you must first operate the engine at idle until the engine is fully warmed up. When the weather is very cold, do not operate the engine in an overloaded condition or at a high speed after starting the engine.

When draining water from the engine cooler or injecting water to the engine cooler, work slowly to ensure that all air inside the cooler is expelled. EDL013016A 1) Remove the water temperature sensor (E). When a defect is found in the thermostat, replace it with a new one. 2) Disconnect the rubber hose (D). 3) Loosen the flange nut and spcae bolt (C). 4) Loosen the 3 flrange hex bolts (B). 1 5) Remove the thermostat (A). 4 2 3 EDL022060A 1. Heat Exchanger 3. water pump 2. Bypass valve 4. Coolant pipe 7 - 8 A C E B D