Doosan Infracore D18NAP — Oil Pump Assembly

8. Lubrication System CAUTION Remove foreign substances such as residues and LOCTITE from the oil seal assembly bore. Do not reuse the oil seal; replace it with a new one. Be careful not to damage the oil seal when attaching it. 5) Remove the foreign substances on the timing gear case assembly surface and clean it with a dry cloth. 6) Apply LOCTITE 5902 to the timing gear case F EDL013053A assembly surface (F) with the diameter of ш 2.5 ± 0.5mm. CAUTION Keep clean liquid gasket dispensing surface. Dispensing line should not be snapped. A 7) Align the timing gear case (A) with the pin and attach it. CAUTION B Be careful that the timing gear case has been attached in the right direction.

Assemble the timing gear case in 5 minutes after dispensing liquid gasket. Do not pressureize inside the timing gear case in 25 minutes after dispensing liquid gasket. D E C EDL013037A 1) Make the assembly surface of the timing gear case face the ground. 2) Mount the front oil seal (E) to the front oil seal 8) Tighten 16 hex bolts (B) at a tightening torque of 2.2kgf m. assembly jig (860104-02047). 9) Attach the crank speed sensor (C). 10) Tighten the fixing bolt (D). 3) Align the front oil seal assembly jig (860104- 02047) where the front oil seal (E) is mounted to 4. Attach the crankshaft pulley. the timing gear case (A) and beat it with a rubber hammer.

4) when the front oil seal (E) is inserted to the timing gear case(A), pull off the front oil seal assembly jig A (860104-02047). CAUTION B Be careful in noting the direction of the oil seal assembly and ensuring that the oil seal surface fasces the outside of the engine. Be careful of the depth of the oil seal when attaching it. Be careful not to damage the oil seal. Attach the oil seal without applying lubrication. coolant, fuel, LOCTITE, or silicon. EDL013033A 8 - 8