8. Lubrication System 1) Align the crankshaft pulley (A) to the pin and 2. Remove the oil pan. attach it. 2) Apply LOCTITE Blue 587 to the inside of the flange hex bolts (B). 3) Tighten flange hex bolts (B) at a tightening torque of 26 kgf m. CAUTION A Be careful not to damage the oil seal. B Fix the crankshaft to allow the flange hex bolts to be tightened with the specified torque. 5. Attach the V-belt. EDL013034A 6. Inject the engine oil. 1) Loosen 22 flange hex bolts (B). 1) Open the oil injection cap. 2) Remove the oil pan (A). 2) Inject engine oil. 3. Remove the oil suction pipe and oil delivery pipe. WARNING Use genuine engine oil recommended.
B C Disassembly of Oil Suction Pipe and Oil Delivery Pipe 1. Drain the engine oil. D 1) Place a container under the engine to drain the A 2) Remove the oil cap. engine oil. 3) Remove the drain plug and drain the engine oil. WARNING EDL013035A Discard oil according to the regulations set forth by the relevant authorities. Disposing of discharged oil into the ground, sewers, drains, rivers, or the sea will cause serious environmental pollution. Violation of regulations when discarding engine oil without observing the handling regulations, will be punished. 1) Loosen 3 hex bolts (D) and 2 hex bolts (C). 2) Remove the oil suction pipe and the oil delivery 3) Remove 3 O-rings (A). pipe (B). 8 - 9