Doosan Infracore D18NAP — Injector Assembly

9. Fuel System Injector Assembly CAUTION 1. Attach the injectiors. Do not reuse the injector seal ring washers. Reuse of the injector seal ring washers may cause critical damage to the engine due to unstable combustion. B D Injector Check 1. Check if there are any foreign substances and if C the end part of the injector is transformed. A 2. Check the injector protrusion (C). EDL013026A B 1) Align the injector seal ring washer (A) with the A center of the injector hole and mount it. 2) Sufficiently apply engine oil on the cylinder head cover surface where the injectors contact. 3) Attach 3 injectors (B).

C CAUTION Do not reuse the head cover rubber seal and the injector oil seal but replace with new ones. 1) Detach the cylinder head (A). EDL013074A Attach injectors by slowly turning them to prevent damage to the cylinder head cover surface which contacts the injectors. Note) Detach the cylinder head by referring to engine disassembly order in Chapter 6. Do not reuse the injector seal ring washers. Otherwise, critical damage to the engine may occur because of unstable combustion. 2) Insert the seal ring in the cylinder head (A) and attach the injector (B). 3) Check the injector protrusion (C) based on the cylinder head (A) surface with a dial gauge. 4) Mount 3 injector fixtures (C).

Note) Be careful not to allow foreign substances to flow into the injector and the high-pressure connector when detaching and checking the injector. 5) Temporarily tighten 3 hex bolts (D). CAUTION Do not tighten the hex bolts by force when it is difficult to tighten them temporarily. Forced tightening may cause damage to the cylinder head. 6) Tighten 3 hex bolts (D) at a tightening torque of 3.5 kgf m. 9 - 9 Item Specified Value Injector protrusion 1.5 ± 0.65 mm