10. Intake/Exhaust System How to Maintain Turbocharger 1. Cautions for engine operation 1) Observe the followings when starting, operating, and stopping an engine. 2. Cautions for Maintenance cooled and lubricated, causing bearing burn and 1) When the RPM is rapidly increased after starting the engine, the journal bearings in the crankshaft 2) Please operate the engine for two minutes or more damage of the related parts. is excessively rotated, the crankshaft is rotated at in order to lubricate the turbocharger fully after excessive speed before the journal bearing of the 3) If an engine has been operated at high speed for a replacing the engine oil or oil filter.
crankshaft is lubricated fully. If the turbocharger rotates in this situation, bearings are not smoothly long period, fully operate the engine at idle and then stop the engine. Otherwise, the turbine wheel 10 - 13 Item Cautions Reasons Starting an engine 1) Check the oil amount 2) Therefore, start the engine with the starter motor to check the rise of oil pressure (until the gradation of the oil pressure gauge moves or the pressure indicator lamp is turned on). 1) Overhasty start of engine leads to engine rotation without lubricating turbocharger and other engine parts, causing abnormal wear or burning of bearings.
2) If you replace oil, oil filter cartridge, or lubrication system parts or use an engine in cold areas, or the engine has stopped for a long period, loosen the oil pipe joint at the inlet of the turbocharger and run the starter motor until oil flows out. After completing the work, tighten the oil pipe joint again and start the engine. 1) When an engine has stopped or kept cold for a long period, circulation of oil in the pipe gets poor. After starting an engine 1) Operate the engine at idle for five minutes from starting it.
1) When the engine is suddenly loaded while the engine and the turbocharger have not been smoothly rotated after starting the engine, parts with insufficient oil may be burnt. 2) Check if oil, gas, or air is leaked from each part. If so, take proper action. 1) Leakage of oil, gas, or air (especially oil) reduces oil pressure and loss of oil cause burning of bearings. During Operation check the following. 1) Oil pressure At idle: 1.5 ~ 3.0 kg/cm2 Fully loaded: 3.0 ~ 5.5 kg/cm2 1) Too low oil pressure causes abnormal wearing or burning of bearings. Too high oil pressure causes oil leakage.
2) When abnormal noise or vibration occurs, slowly reduce the rotate count until the engine stops and then figure out the causes. 1) Operating an engine with noise or vibration may cause irreversible damage of the engine. Stopping an Engine 1) Operate the engine at idle for five minutes before stopping it. 1) Sudden engine stop after operating the engine under high load allows the heat from the red-heated turbine blade to be delivered to the bearing system. Then oil burns and the bearing metal and rotation shaft are burnt.