Doosan Infracore D18NAP — Turbocharger Check

10. Intake/Exhaust System 2. Remove the turbocharger. too high, the filter absorbs oil and contaminates the case. Especially, when the rotor is contaminated, the precisely adjusted balance is broken, causing vibration. In addition, the bearings are overloaded, resulting in bearing burn and abnormal wearing. Therefore, an air filter should be carefully used and maintained according to the instructed and specified ways. For a dry type air filter, the intake resistance should be small as possible. 2) Exhaust system: For the exhaust system, when exhaust gas leaks from the exhaust pipe or turbocharger joint, supercharging efficiency is lowered.

So you need to pay attention to prevent gas leakage and burn. Heat resistant nuts are used for parts which are highly heated during operation, such as turbine seal, and the nuts should not be mixed with other nuts. The screw burn prevention paint should be applied to the assembly nuts of the specified positions. 3) Lubrication system: For the lubrication system, be careful with the oil quality and the replacement time of the cartridge of the oil filter. Degradation of engine oil has bad effect on the turbocharger, as well as the engine body. 1 A B D C E EDL013007A 2 A B C 2. Regular Inspection and Repair: The state and contamination of a turbocharger should be checked regularly.

1) How to check the rotating state of a rotor assembly: You can check the rotating state of a rotor assembly by checking the abnormal sound which occurs while the solid of rotation is rotating. If you use a sound rod, contact the neb of the sound rod to the turbocharger housing and slowly raise the RPM. If high-pitched sound continues, it means that the state is abnormal. In this case, the bearing or the rotor assembly may be abnormal. So you need to replace or repair the turbocharger. 2) How to detach and check the turbocharger: D EDL013008A 1) Disconnect the oil return pipe. Note) The oil return pipe is that TYPE-1 is (E) and TYPE-2 is (D) .

2) Loosen 2 hollow screws from the oil delivery pipe. Note) Loosen the fixing bolt(D) if the engine is TYPE-1. 3) Disconnect the oil delivery pipe (C). 4) Loosen 4 flange hex nuts (B) Detach the turbocharger from the engine and 5) Remove the gasket and the turbocharger (A). clean or check it. At this time, seal the oil inlet and outlet with sealing tape. 3) Cautions for attaching the turbocharger to the Turbocharger Check engine: Please observe the following precautions 1. Routine Check and Repair: The turbocharger per- as attaching the turbocharger to the engine and handling it after attaching. Especially, be careful formance is determined by maintenance state of the engine.

So you should regularly perform not to let foreign substances flow into the inspection and check as specified. turbocharger. 1) Intake system: For the intake system, the air filter should be carefully managed. For a wet type air filter, if the oil amount is lower than the specified amount, filtering efficiency is lowered. On the contrary, if it is Lubrication system: Before attaching the turbocharger to the engine, inject new oil into the oil inlet and spin the turbine shaft to lubricate journal bearings and thrust bearings. 10 - 15