10. Intake/Exhaust System Cleanse the pipes from starting from the engine to the oil inlet and outlet and check if there is any damage of the pipes or foreign substance in the pipe. Precisely connect the oil pipes to prevent oil leaks. 2) Tighten 4 flange hex bolts (B) at a tightening torque of 2.2 kgf•m. 3) Connect the oil delivery pipe (C). 4) Tighten 2 hollow screws from the oil delivery pipe Intake system: Check if there is any foreign substance within the intake system. Precisely attach the intake system to the engine to prevent air leaks from the joints of the intake system and the air filter. at a tightening torque of 2.0 kgf•m.
Note) Tighten the fixing bolt (D) if the engine is TYPE-1. 5) Connect the oil return pipe. Note) The oil return pipe is that TYPE-1 is (E) and TYPE-2 is (D). Exhaust system: Check if there is any foreign substance in the exhaust system. The heat-resistant bolts and nuts should be used. Do not use any of general nuts and bolts. Apply burn prevention paint to the bolts and nuts. Precisely attach the exhaust system to the engine to prevent gas leaks from the exhaust system joints. CAUTION Be careful to note the direction when connecting the hose and gasket. Be careful not to damage the gasket while mounting it. Do not reuse the hose clamps but replace them with new ones.
Do not reuse the oil delivery pipe but replace it with new one. Turbocharger Assembly 1. Attach the turbocharger. 1 2. Attach the breather hose. A B 1 D A C E EDL013007A EDL013001A 2 2 A A B C D EDL013008A 1) Attach the gasket and the turbocharger(A). EDL013002A 10 - 16