Doosan Infracore D18NAP — Disassembly of EGR Valve

10. Intake/Exhaust System 3. Remove the common rail and the injection pipes. CAUTION Be careful to note the direction when attaching the the EGR connection pipe. Be careful not to damage the gasket while attaching it. C A B 3) Tighten 6 fixing bolts(B) at a tightening torque of 2.2 kgf m. E D Disassembly of EGR Valve 1. Remove the EGR connection pipes. A EDL013006A 1) Loosen the fixing bolt (E). 2) Loosen the nuts of the fuel injection pipes. 3) Remove 4 fuel injection pipes (C) and (D). CAUTION Do not reuse fuel injection pipes; replace them with new ones.

If fuel injection pipes are reused it may allow foreign substances into the fuel pipes or cause oil leaks from bolt clamping and cause a critical fault in engine performance. B EDL013004A 4) Loosen 2 collared hex bolts (B) of the common rail. 5) Remove the common rail (A) from the intake manifold. 1) Loosen 6 fixing bolts (B). 2) Remove the EGR pipes (A). 3) Remove 4 gaskets. 4. Remove the oil filter assembly. 2. Remove the intake stake. D C D C A A B B EDL01300 9 A 1) Loosen thefixing bolt (D). EDL013005A 2) Disconnect the coolant hose (C). 1) Loosen the flange hex bolt (D). 2) Remove the boost pressure sensor (C). 3) Loosen 3 flange hex bolts (B).

4) Remove the gasket and the intake stake (A). 4) Remove the 3 O-rings and the oil filter assembly (A). 3) Loosen 5 flange hex bolts (B). 10 - 24