Doosan Infracore D18NAP — Assembly of EGR Valve

10. Intake/Exhaust System Assembly of EGR Valve CAUTION 1. Assemble the EGR valve. Oil in the filter may run down while removing the oil filter. Be careful not to contaminate the other parts by using a cloth when removing the filter. After replacing the oil filter, wipe clean any other parts which the oil has touced. 5. Remove the intake manifold. j C i B B h A C EDL013081A A 1) Attach the gasket (C) and the EGR valve (B) to intake manifold. 2) Tighten 3 fixing bolts (A). 2. Attach the intake manifold. EDL013010A 1) Remove the boost temperature sensor (C). 2) Loosen 8 flrange hex bolts (B). B 3) Remove the gasket and the intake manifold (A) from the cylinder block. C 6.

Disassemble the EGR valve. A j C EDL013010A 1) Attach the gasket and the intake manifold (A). i B CAUTION Be careful to note the direction when mounting the gasket. Be careful not to damage the gasket while mounting it. h A EDL013081A 2) Tighten 8 flange hex bolts (B) at a tightening 1) Loosen 3 fixing bolts (A). torque of 2.2 kgf m. 2) Remove the EGR valve (B) and the gasket (C) from the intake manifold. 3) Attach the boost temperature sensor (C). 10 - 25