11. Cylinder block/head 2) Loosen the flange hex bolt (B). CAUTION 3) Disconnect the oil level gauge gauide tube (A). Keep clean liquid gasket dispensing surface. Dispensing line should not be snapped. 2) Attach the oil pan (A). Assembly of Engine Oil Level Gauge and CAUTION Guide Tube 1. Attach the oil level gauge. Be careful that the oil pan has been attached in the right direction. Assemble oil pan in 5 minutes after dispensing liquid gasket. Do not pressurize inside oil pan in 25 minutes after dispensing liquid gasket. C A 3) Tighten 22 flange hex bolts (B) at a tightening torque of 2.2 kgf m. CAUTION B Tighten flange hex bolts in the order from (1) - (22).
The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. EDL013003A 1) Attach the oil level gauge guide tube (A) in the 2. Inject the engine oil. cylinder block. 1) Open the oil injection cap. 2) Tighen the flange hex bolt (B) at a tightening 2) Inject engine oil. 3) Insert the oil level gauge (C). torque of 1.0 kgf m. WARNING Use genuine engine oil recommended. CAUTION Make the handle of the oil level gauge face the reverse direction from the center of the engine. Disassembly of Engine Oil Level Gauge and Guide Tube 1. Remove the oil level gauge. C A B EDL013003A 1) Remove the oil level gauge (C). 11 - 17